© Edwards Limited 2015. All rights reserved. Page 41
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A352-03-880 Issue B
7.4.7 Oil level sensor and PT100 (ES200 / ES300)
Figure 19 - ES200/ES300 oil level sensor and PT100
Fitting Instructions (refer also to Table 13):
Note: Figure 19 shows the oil level sensor and PT100. See Figure 18 to see where this part locates.
1. Drain oil from pump.
2. Remove the blank plate and seal.
3. Clean the area where oil level sensor and PT100 (Figure 19) will be fitted.
4. Carry out a visual check on the sealing face of both the pump and the oil level sensor.
5. Secure using fixings provided.
Product Item Number
ES200/ES300 oil level sensor and PT100 A352-77-812
To Next Page
Loading...
