© Edwards Limited 2015. All rights reserved. Page 43
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A352-03-880 Issue B
7.4.9 Oil level sensor (ES630)
Figure 21 - ES630 oil level sensor
Fitting Instructions (refer also to Table 13):
1. Drain oil from pump.
2. Remove the blank plate (Figure 21, item 1) and O-ring.
3. Clean the area where the oil level sensor (2) will be fitted.
4. Carry out a visual check on the sealing face of both the pump and the oil level sensor.
5. Secure using fixings provided.
Product Item Number
ES630 oil level sensor A352-88-810
To Next Page
Loading...
