© Edwards Limited 2015. All rights reserved. Page 45
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
A352-03-880 Issue B
7.4.11 Oil level sensor and PT100 (ES630)
Figure 23 - ES630 oil level sensor and PT100
Fitting Instructions (refer also to Table 13):
Note: Figure 23 shows the oil level sensor and PT100. See Figure 22 to see where this part locates.
1. Drain oil from pump.
2. Remove the blank plate and seal.
3. Clean the area where oil level sensor and PT100 (Figure 23) will be fitted.
4. Carry out a visual check on the sealing face of both the pump and the oil level sensor.
5. Secure using fixings provided.
Product Item Number
ES630 oil level sensor and PT100
o
A352-88-812
To Next Page
Loading...
