Edwards ES100

A352-03-880 Issue B
Page 2 © Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
Figure 1 - ES65 and ES100 pumps
Figure 2 - ES200 and ES300 pumps
1. Motor terminal box
2. Oil filler plug
3.
Lifting bracket
4. Inlet and integral non-return valve
5. Exhaust
6. Gas ballast control
7. Oil level sight glass
8. Oil drain tap
Space needed:
A. 200 mm (Cooling)
B. 400 mm (Maintenance access)
C. 500 mm (Maintenance access
and cooling)
Space needed:
A. 200 mm (Cooling)
B. 400 mm (Maintenance access)
C. 500 mm (Maintenance access
and cooling)
1. Motor terminal box
2. Oil filler plug
3. Lifting bracket
4. Inlet and integral non-return valve
5. Exhaust
6. Gas ballast control
7. Oil level sight glass
8. Oil drain tap