90 Installation and Service Guide
Performing Backup and Restore
2 In Backup dialog box, select the media in which you want your backup file saved, and click Continue.
• USB: Select this option when you create a backup on a USB flash drive. If you want to create a backup of the
current E-35A on the USB flash drive, select New image. You can select Create bootable image to make the USB
flash drive a bootable media.
If you want to create a factory image backup on a USB flash drive, select Fiery factory image. The Create
bootable image option will be automatically turned ON.
Note: The minimum size for the USB flash drive depends on the actual size of the backup file. You can
determine the size of the backup file by checking the Estimated size: field in the Create USB Backup dialog box.
Prepare the USB flash drive with enough capacity.
Note: Due to a file system restriction, the maximum size of the USB flash drive is 32GB if the Create bootable
image option is ON. You can use the USB flash drive with more than 32GB capacity if the Create bootable image
is OFF.
• Internal hard drive: Select this option when you create a backup on the internal HDD of the E-35A. You must
specify the file name of the backup image. The default image name is the server name of the E-35A.
3 Make sure to connect the USB drive to the USB connector on the E-35A.
Note: If the capacity of the USB flash drive is less than size of the value listed in Estimated size: field, the backup
process will not take place.
4 Click Continue.
To restore the backup image
1 In Fiery System Restore window, click Restore.
If you have not logged in as an Administrator user, you are required to do so. Enter the administrator’s password
(default password is Fiery.1), and then click Log In.
2 Make sure the E-35A backup image is accessible from the E-35A.
If you want to restore the E-35A backup image stored on a USB flash drive or USB hard disk drive, attach the USB
storage device to one of the USB 3.0 ports on the E-35A.
3 Select one of the following restore options:
• Restore from a local image
• Restore from a USB storage device
• Restore from the factory default image
4 Click Continue.
5 Follow the on-screen prompts to restore the backup image.
Note: The E-35A must remain powered ON during the backup or restore process.
To Next Page
Loading...
Need help?
General
