- AB620A5035
1 Range of Applications
The drive is suitable for lockstitch, chainstitch and overlock machines of various manufacturers.
It can be operated with or without control panel.
The easy-to use V810 or V820 control panels extend the range of functions.
With the help of adapter cords (adapter cords see Special Accessories), the drive can be used in replacement of
the controls listed in the table below, as long as backtacking, stitch condensing, and chain suction are not used.
W500/UT, W600/UT/MS,
with/without stitch
condensing
Medium-duty sewing machine,
general
e.g. Dürkopp Adler, Juki,
Pfaff, Sunstar, Golden
Wheel
Suitable
adapter, upon
request
1.1 Use in Accordance with Regulations
The drive is not an independent functional machine. It has been designed for integration into other machines by
trained specialists.
It must not be put into service until the machinery into which it is to be incorporated has been declared in
conformity with the provisions of the EC Directive (Appendix II, paragraph B of the Directive 89/392/EEC and
supplement 91/368/EEC).
The drive has been developed and manufactured in accordance with the relevant EC standards:
IEC/EN 60204-31 Electrical equipment of industrial machines:
Particular requirements for industrial sewing machines, sewing units and sewing systems.
Operate the drive only in dry areas.
ATTENTION
When selecting the installation site and the layout of the connecting cable, the Safety
Instructions must be followed with no exceptions.
Particular attention should be paid to maintaining the proper distance from moving parts!
To Next Page
Loading...
