Efka AB620A5035 - 4 Setting and Putting into Service with the Aid of the Fast Installation Routine (SIR)

- AB620A5035
- 9 -
Before putting the control into service, the following must be ensured, checked and/or adjusted:
 Selection of motor type using parameter 467
 The correct installation of the drive, position transmitter and accompanying devices, if necessary
 The correct selection of the trimming operation using parameter 290
 If necessary, the correct adjustment of the direction of motor rotation using parameter 161
 The correct selection of the functions of keys (inputs) using parameters 240...246
 The setting of the transmission ratio between motor shaft and machine shaft using parameter 272
 The setting of the type of position sensor using parameter 270
 If necessary, the adjustment of the positions using parameter 171
if necessary, the setting of the positions using parameter 171 (possible with all settings of parameter 270)
 The correct positioning speed using parameter 110
 The correct maximum speed compatible with the sewing machine using parameter 111
 The setting of the remaining relevant parameters
 Begin sewing in order to save the set values
4 Setting and Putting into Service with the Aid of the Fast Installation
Routine (SIR)
Function with or without control panel
Parameters
Call-up of the Fast Installation Routine SIR
(Sir)
500
The Fast Installation Routine (SIR) passes through all parameters necessary for programming the functional
sequence and the positions.
With SIR you can do the most important settings for initial operation with menu prompting.
For safety reasons, the menu must be executed point by point. This ensures correct setting of all important
parameters.