EG4 LuxPowerTek 6000XP User Manual

51
24
Fan Speed Setting
This setting allows the user to
adjust the operation of the
Inverter’s two fans. The user
can set the speed (20-100%)
and enable or disable the
slope (Enabling the slope
allows the fans to ramp
up/down to/from the fan speed
setting).
Fan1/2 Slope: Enable/Disable
Default: Disable
Range: 20 – 100%
Default: 70%
25
Generator Charge
Setting
This setting allows the user to
select the Generator charge
control parameter (Voltage or
SOC) and the associated
Start/End Voltage or SOC.
Generator Charge Control Type: VOL or SOC
Default: VOL
Generator Charge Control Value (Volts):
Start Voltage: 38.4 – 52V, End Voltage: 48 – 59V
Generator Charge Control Value (SOC):
Range: Start SOC: 1 – 90%, End SOC: 20 – 100%
26
Neutral-Ground
Bonding Function
This setting allows the user to
enable or disable the internal
neutral-ground bond. The
inverter must be in standby to
make this change. Turn the
“EPS Output” switch to off to
engage standby mode.
Range: Enable/Disable
Default: Enable

EG4 LuxPowerTek 6000XP Specifications

General

Category	Inverter
Rated Power	6000W
Max DC Input Power	7800W
Number of MPPT Trackers	2
Battery Voltage	48V
Max Charge/Discharge Current	120A
Protection Degree	IP65
Frequency	50/60Hz
Model	LuxPowerTek 6000XP
Communication	RS485
Operating Temperature Range	-25°C to 60°C
Protection Features	Over Voltage Protection, Over Temperature Protection
Cooling	Fan