Eldes EPIR3 - Page 115

115
115EN
EPIR3 User Manual v1.3
FOTA
EPIR3 alarm system supports FOTA (rmware-over-the-air) feature. This
allows to upgrade the rmware remotely via GPRS connection. Once the
upgrade process is initiated, the system connects to the specied FTP
server address where the rmware le is hosted and begins downloading
and re-ashing the rmware. The rmware le must be located in a folder
titled Firmware. In order to initiate the upgrade process, please, send the
following SMS message.
SMS text message content:
XXXX_FOTA:ftp-server-IP,port, rmware-le-name.bin,user-name,password
Value: ftp-server-IP - IP address of FTP server where EPIR3 rmware le is
stored; port - port number of FTP server (usually - 21); rmware-le-name.
bin - name of the rmware le, allowed max. length - up to 31 character;
user-name - user name of FTP server login, allowed max. length - up to 31
character; password - password of FTP server login, allowed max. length - up
to 31 character.
Example:
1111_FOTA:84.15.143.111,21,EPIR3fw. bin,eldesuser,eldespassword
ATTENTION: Firmware lename MUST be renamed in lowercase format before using it.
ATTENTION: Comma and underscore character is NOT allowed to use in user name, password and rmware
le name.
ATTENTION: “ELDES UAB” does not run a FTP server and does not host the rmware les online. Please,
contact your local distributor to request the latest rmware le.
NOTE: It is strongly recommended to restore default parameters after the rmware update.