Eldes EPIR3 - HOW TO PROGRAM THE SYSTEM USING YOUR MOBILE PHONE

44
44 EN
EPIR3 User Manual v1.3
4. HOW TO PROGRAM THE SYSTEM USING YOUR MOBILE PHONE
NOTE: The system supports a exible SMS text message management replies.
In order to congure and control the EPIR3 system using SMS text message, send the text command to the phone
number of EPIR3 from one of the pre-programmed user numbers.
ESSENTIAL INFORMATION FOR PROGRAMING VIA YOUR MOBILE PHONE
• The underscore symbol ‘_’ in these instructions represents a space. So when following instructions and ty-
ping an SMS text message, replace the underscore symbol with a single space.
• Similarly, ‘XXXX’ means password.
• Make sure you don’t leave any spaces at the beginning or end of the message.
• If you receive the message “wrong syntax” please check your message and try again.
Main Settings
Function Command Value Range / Comment Example
Change
the SMS
password
0000_PSW_XXXX XXXX = [0001... 9999]
All SMS text message commands start with
a password, so be sure to change the default
password to a memorable number. It must be
a four digit number – anything except four
zeros. Non-numerical characters such as
dots, colons and spaces are not allowed.
0000_PSW_1111
Add or
change
a single
user phone
number
XXXX_NRn:
+441700XXXX111
or XXXX_NRn:
00441700XXXX111
or XXXX_
NRn:01700XXXX111
NRn = [NR1... NR10]
The EPIR3 alarm system allows you to enter up
to ten dierent mobile numbers to gain access
to and control the system. User 1 number is
mandatory - all the others can be skipped.
All numbers must be entered in one of the
following formats:
• International (with plus) – The phone
numbers starting with plus and an interna-
tional country code in the following format:
+[international code][area
1111_
NR1:+44321XXXX4
NOTE: The underscore symbol ‘_’ in these instructions represents a space. So when typing an SMS text
message, replace the underscore symbol with a single space.