Eldes EPIR3 - Alarm Indications and Notifications

97
97EN
EPIR3 User Manual v1.3
7.8. Alarm indications and notications
When a zone, depending on zone type (see section 7.4.3. Zone type denitions), or tamper is
violated, the system will cause an alarm. By default, the alarm duration is 1 minute (see section 7.7.
Siren regarding the alarm duration). During the alarm, the system will follow this pattern:
1. The system activates the siren.
a) The siren will emit pulsating sound if the violated zone is of Fire type, otherwise the sound will be
steady.
b) The EKB3W wireless keypad buzzer will emit short beeps.
NOTE: Alarm must be caused only on EKB3W zone.
e) If one or more zones are violated and keypad are manually waked up, EKB3W will light ON the
corresponding violated zone indicator (-s) ranging from 1 through 12. Indicator SYSTEM will ash
if one or more high-numbered zones are violated. If one or more tampers are violated, indicator
SYSTEM will light ON. For more details on viewing violated high-numbered zone and tamper
numbers by EKB3W keypad, please refer to section. 3.3.8. Fault messages.
For more details on how EKB3W keypad operates and indicates the alarms, please refer to section
3.3.1. Sleep mode, how to wake up EKB3W and view system alarms or faults.
2. The system attempts to send an SMS text message, containing the violated zone/tamper name
(see section 7.4.5. Zone names and 7.5.1. Tamper names on how to set a zone or tamper name
respectively), to the rst preset user phone number. The system will send SMS text messages
regarding each violated zone/tamper separately.
a) If the user phone number is unavailable and the system fails to receive the SMS delivery report during
45 seconds, it will attempt to send the SMS text message to the next preset user phone number. The
user phone number may be unavailable due to the following reasons:
• mobile phone was switched o.
• was out of GSM signal coverage.
b) By default, the system will continue sending the SMS text message to the next preset user phone
numbers in the priority order until one is available. The system sends the SMS text message only once
and will not return to the rst user phone number if the last one was unavailable.
3. By default, the system attempts to ring the rst user phone number The system will dial regarding each
violated zone/tamper separately.
a) When the call is answered, the system will shut down the siren and the user will be able to listen on the
mobile phone for approx. 30 seconds to what is happening in the area, surrounding the alarm system.
b) The system will dial the next preset user phone number,, if the previous user was unavailable due to
the following reasons:
• mobile phone was switched o.
• mobile phone was out of GSM signal coverage.
• provided “busy” signal.