Eldes EPIR3 - HOW TO PROGRAM THE SYSTEM USING EKB3 W WIRELESS KEYPAD

57
57EN
EPIR3 User Manual v1.3
5. HOW TO PROGRAM THE SYSTEM USING EKB3W WIRELESS KEYPAD
In order to congure and control the EPIR3 system using EKB3W wireless keypad, please refer to the following
information rst.
ESSENTIAL INFORMATION FOR PROGRAMING VIA EKB3W WIRELESS KEYPAD
• Before conguring the system using EKB3W wireless keypad, the Conguration mode must be activated by
entering [INST]adminpassword# command. By default the command is [INST]1470#.
• To deactivate Conguration mode, enter the aforementioned command again.
• If you entered unnecessary characters by mistake, press [*] key to clear the characters that have been
entered. Alternatively, you can wait for 10 seconds until the keypad buzzer will provide a long beep indicating
that the entered characters have been cleared.
The following table provides a list of EKB3W wireless keypad indications, which are relevant during Conguration
mode.
Indication Description
Indicator ARMED ashing Conguration mode activated successfully.
Indicator SYSTEM ashing Valid parameter is entered and waiting for valid value to be enetered.
1 long beep Non-existing command or invalid parameter value entered.
3 short beeps Command entered successfully.
NOTE: The system can be congured using only one keypad at a time. Other connected keypads will be
inactive while the Conguration mode is activated.
NOTE: Conguration mode will automatically deactivate if 1 minute after the last key-stroke expires.