Eldes EPIR3 - System configuration using ELDES Configuration Tool software

111
111EN
EPIR3 User Manual v1.3
7.12. System conguration using ELDES Conguration Tool software
Software ELDES Conguration Tool is intended for EPIR3 system conguration locally via USB port or remotely via
GPRS network connection. This software simplies system conguration process by allowing to use a personal
computer in the process. Before starting to use ELDES Conguration Tool software, please read the user guide
provided in the software’s HELP section.
ELDES Conguration Tool is freeware and can be downloaded from at: www.eldes.lt
NOTE: ELDES Conguration Tool software is secured with administrator password. The default administrator
password is 1470.
7.12.1. Remote connection
ATTENTION: The system will NOT send any data to the monitoring station while remote conguration,
remote rmware update or remote listening is in progress. However, during the remote conguration session,
rmware update process or remote listening process, the data messages will be queued up and transmit-
ted to the monitoring station after the remote conguration session, rmware update or remote listening
process is over.
NOTE: EKB3W keypad (if any) becomes inactive while the system is being congured remotely.
NOTE: When the Conguration mode is activated by EKB3W keypad, remote system conguration is disabled.
ELDES Conguration Tool software provides remote system conguration ability via Internet using one of the
following methods:
• ELDES proxy server (recommended). The connection can be established on the system via GPRS network.
• Running TCP/IP server on ELDES Conguration Tool (advanced). The connection can be established on the
system via GPRS network.
In order to start using the remote conguration feature, please run the step-by-step wizard and follow the steps
provided in the start page of ELDES Conguration Tool software. Please, note that it will be necessary to send
an SMS text message to the system’s phone number in order to initiate the remote connection. By following the
steps you will be instructed on what text must be sent to the system’s phone number in such case.