Eldes EPIR3 - Page 110

110
110 EN
EPIR3 User Manual v1.3
By default, if the initial attempt to transmit data to the monitoring station’s Tel Number
1 via Voice Calls or SMS method is unsuccessful, the system will make up to 4 additional
attempts. After all unsuccessful attempts, the system will continue to communicate with
the monitoring station by switching to the next phone number that follows in the sequence
and making up to 4 additional attempts if the initial attempt is unsuccessful. If all attempts
to all phone numbers are unsuccessful, the system will switch to next backup connection
that follows in the sequence and will attempt to transmit data until it is successfully
delivered to the monitoring station.
Due to the individual conguration of each monitoring station, the system may fail to deliver
the data message via Voice Calls communication method. In such cases it is recommended
to adjust the microphone gain until the optimal value, leading to successful data message
delivery, is discovered.
7.11.2.3. CSD
The system supports up to 5 monitoring station phone numbers for communication with the alarm system by CSD
communication method. Tel. Number 1 is mandatory, the other four can be used as backup phone numbers and are
not necessary. The supported phone number formats are the following:
• International (with plus) – The phone number must be entered starting with plus and an international country
code in the following format: +[international code][area code][local number], example for UK: +441709111XXXX.
This format can be used when setting up the phone number by ELDES Conguration Tool software.
• International (with 00) – The phone number must be entered starting with 00 and an international
country code in the following format: 00[international code][area code][local number], example for UK:
00441709111XXXX. This format can be used when setting up the phone number by EKB3W keypad.
To set up the system for data transmission via CSD, please follow the basic conguration steps:
1. Enable MS Mode parameter (see 7.11. Monitoring Station).
2. Set 4-digit Account number (see 7.11. Monitoring Station).
3. Set Tel. Number 1... 5.
By default, if the initial attempt to transmit data to the monitoring station’s phone number
via CSD method is unsuccessful, the system will make up to 4 additional attempts. If all
attempts are unsuccessful, the system will switch to next backup connection that follows
in the sequence and will attempt to transmit data until it is successfully delivered to the
monitoring station.