Eldes EPIR3 - Plug the Power Supply Connector into the Device; Place the Device into the Holder; Slide the Device down to Fix It; Insert the Plug into the Mains Socket

15
15EN
EPIR3 User Manual v1.3
29
30
31
2.4. Plug the power supply
connector into the device
2.5. Place the device into the
holder
2.6. Slide the device down to
x it
32
33
The system will start in 1 - 2 minu-
tes. To test that the system is wor-
king, when the red LED is switched
o move your hand in front of the
EPIR3 lens. The system will detect
the motion and the LED will light up
for a few seconds.
NOTE: Ensure that the device
is properly xed into the holder,
otherwise it will prevent from
using the back tamper switch
for supervision of the enclo-
sure‘s back side. For more
information see the diagram
of the EPIR3 and the description
of components on page <5>.
2.7. Insert the plug into the
mains socket
2.8. How to check the detector
is working
If the LED indicator blinks fast (a few times a second), the SIM card may not be inserted properly or
the PIN code may not have been disabled.
QUICK START GUIDE