Eldes EPIR3 - How to Upgrade the Firmware Remotely Via GPRS Connection

114
114 EN
EPIR3 User Manual v1.3
99
7.15. How to upgrade the rmware remotely via GPRS connection
ATTENTION: The system will NOT transmit any data to monitoring station while updating the rmware re-
motely via GPRS network. All data messages will be lost and will NOT be transmitted to the monitoring station
after the rmware upgrade process is over.
Before updating the rmware remotely via GPRS connection, make sure that:
• SIM card is inserted into SIM card slot of EPIR3 device.
• Mobile internet service (GPRS) is enabled on the SIM card.
• Power supply is connected to EPIR3 device.
• Default SMS password is changed to a new 4-digit password.
• At least User 1 phone number is set up.
• APN, user name and password are set up - please, contact your GSM operator to nd out these parameters.