Eldes EPIR3 - System Notifications

98
98 EN
EPIR3 User Manual v1.3
• user did not answer the call after several rings, predetermined by the GSM operator.
c) The system will continue dialing the next preset user phone numbers in the priority order until one is
available. The system will dial the user phone number 5 times if the rst user phone number was out
of GSM signal coverage/switched OFF, otherwise the system will dial only once. If the system ends up
with all unsuccessful to contact any preset user phone number, will stop dialing and will not return to
the rst user phone number.
d) The system will not dial the next preset user phone number if the previous one was available, but
rejected the phone call.
To silent the siren as well as to cease system phone calls and SMS text message sending to the user
phone numbers, please disarm the system using a free of charge phone call, SMS text message,
EKB3W wireless keypad or EWK1/EWK2 wireless keyfob.
For more details details on how to disable/enable SMS text messages and phone calls to preset user
phone number in case of alarm, please refer to section 7.9. System notications.
NOTE: Phone calls to the preset user phone number in case of alarm are disabled by force when
MS mode and/or ELDES Cloud Services feature is enabled (see section 7.11. Monitoring station).
NOTE: If one or more zones/tampers are violated during the alarm, the system will attempt to
send as many SMS text message and dial the user phone number as many times as the zone/
tamper was violated.
NOTE: If the system sent the SMS text message and/or dialed the user phone number after
disarming the system, it means that the SMS text message and/or phone call was queued up in
the memory before the system was disarmed.
7.9. System notications
By default in case of a certain event, the system attempts to send an SMS text message to the rst preset user
phone number only. If the user phone number is unavailable and the system fails to receive the SMS delivery
report during 45 seconds, it will attempt to send the SMS text message to the next preset user phone number,
assigned to the same partition as the previous one. The user phone number may be unavailable due to the
following reasons:
• mobile phone was switched o.
• was out of GSM signal coverage.
The system will continue sending the SMS text message to the next preset user phone numbers in the priority
order until one is available. The system sends the SMS text message only once and will not return to the rst user
phone number if the last one was unavailable.
To change the SMS text message delivery algorithm, user can enable/disable the following parameters for certain
events:
• Send SMS text message to all users simultaneously - This parameter determines whether to ignore