Eldes EPIR3 - In Case of Mains Power Failure; Receiving an SMS Text Message When Temperature Exceeds the Set Values; Additional Capabilities

26
26 EN
EPIR3 User Manual v1.3
in the building.
You can also program the system to send an SMS text message to all users (see ELDES Conguration Tool soft-
ware’s Help section).
NOTE: Due to the dual element technology of a built-in PIR sensor, the device features the pet immunity against
the animals of up to 40 kg weight in order to prevent them from causing false alarms while moving within the
secured premises.
2.14. In case of mains power failure
The system will automatically switch to the back–up battery supply in case of mains power failure. At this time
you will receive an SMS text message warning message after 2 minutes. When the mains power has been re-
stored you will also receive an SMS text message after 2 minutes. Likewise the system will warn you by when
the back-up battery is getting low, just before the system is switched o.
2.15. Receiving an SMS text message when temperature exceeds the set values
The system comes equipped with a feature intended for temperature measurement in the surrounding area.
This feature allows to monitor the temperature and receive a notication by SMS text message, identied as the
Temperature Info SMS, to user phone number when the set temperature MIN or MAX pairedaries are exceeded.
For this purpose you may use the system’s built-in temperature sensor or one of the temperature sensors incor-
porated in the wireless device (if any). The following wireless devices contain a built-in temperature sensor:
• EWP2 – wireless PIR sensor (motion detector).
• EWD2 - wireless magnetic door contact/shock sensor/ood sensor.
• EWS3 – wireless indoor siren.
• EWS2 – wireless outdoor siren.
• EWF1/EWF1CO - wireless smoke/CO detector.
• EW2 - wireless zone and PGM output expansion module supports the temperature measurement feature as
well. However, an external temperature sensor (-s) must be connected to EW2 for this purpose.
By default, temperature measurement feature is disabled. To enable it, please refer to ELDES Conguration Tool
software. To set the MIN and MAX temperature pairedaries, please refer to section 4. HOW TO PROGRAM THE
SYSTEM USING YOUR MOBILE PHONE or ELDES Conguration Tool software.
NOTE: The supported temperature range of EPIR3 is -10... +40 °C and measured at +/-2 °C accuracy. When
temperature sensor of a wireless device is selected, the operating temperature range of the wireless device
corresponds the supported temperature range.
2.16. Additional capabilities
You can also use your mobile to request information about the system, the power supply and the network qual-
ity. Plus you can listen in to what’s happening in the secured location through a remote microphone. See section
3 for more details.
EPIR3 system comes equipped with built-in wireless module allowing to enhance your security system with
the addition ELDES wireless PIRs (Passive Infrared Sensors), sirens, magnetic door and window sensors or
expansion modules. See section 3. HOW TO MANAGE THE WIRELESS DEVICES for more details.