ADL 2010 / 01 16/57 599 72 63-27
4.13 End of cycle
Once the drying cycle has ended, on machines with LCD
the value " 0 " and the clean filter LED will flash.
In models not fitted with an LCD the end of cycle is
indicated by the fact that the END led and the FILTER led
start to flash.
In all models, if the buzzer has been activated, the buzzer
will sound intermittently for about one minute.
Drying cycles are automatically followed by an anti-
crease phase, which lasts approximately 30 minutes.
During this phase the drum turns at intervals to ensure
that the washing remains soft and crease-free.
The washing can be removed from the drum at any time
during the anti-crease phase.
To avoid the formation of creases, it is recommended that
the washing only be removed at the end of the anti-
crease phase.
If the Long anti-crease function has been selected, the
anti-crease phase is extended by a further 60 minutes.
1. Open the door.
2. Remove the washing.
3. Remove the filter and open it as shown in the figure.
4. Clean the filter and if necessary rinse it out with
water so as to remove all residual fluff.
5. Turn the programme selector dial to the OFF
position.
6. Replace the filter.
7. Close the door.
Caution Before fitting the filter again, check that there is
no waste/fluff in the housing.
Important The filter must be cleaned after every drying
cycle.
To Next Page
Loading...
