Electrolux ENV06 - Rear Brush (Only on Models with Conductivity Sensor); Front Brush (Only on Models with Conductivity Sensor)

ADL 2010 / 01 51/57 599 72 63-27
13.18 Rear brush (only on models with conductivity sensor)
1. Unfasten the screw fixing the drum pin guard.
2. Turn the guard anticlockwise until the lower
fixing clip is free.
3. The brush is housed inside the drum pin guard.
13.19 Front brush (only on models with conductivity sensor)
1. Remove the worktop (see paragraph).
2. Disconnect the wires.
3. With the aid of a screwdriver, press on the
locking clip and at the same time remove the
entire brush unit.