ADL 2010 / 01 17/57 599 72 63-27
5 How to operate the appliance
When the selector is moved from the OFF position to a drying programme, the LEDs for the drying phases
light up and the START/PAUSE led flashes.
The various options can be selected during this phase and the relevant LED will light up.
In models with an LCD the time remaining until the end of the drying cycle is displayed, the first figure
indicates the hours, the second and the third indicate the minutes.
If an option that is incompatible with the chosen programme is selected, the Start / Pause LED will flash red
three times, the Buzzer will sound and in models with LCD the Display will show Err .
When one or more options are selected, the Display will show an increase or a decrease in the drying time.
If the option DELICATE or SENSITIVE is selected, an increase in the drying time will be seen on the display.
If the position of the selector is changed after the options have been selected, but before the
START/PAUSE button has been pressed, the options will be reset.
5.1 How a cycle works
A drying cycle starts after a drying programme has been chosen using the selector, any options have been
selected, and the START/PAUSE button has been pressed.
The LED for the START/PAUSE button will remain lit and at the same time the LED or icon relating to the phase
in progress will light up, while the Display will show the maximum drying time.
A drying cycle is made up of the phases described below.
• DRYING
If the cycle is automatic the duration will depend on the amount of time required to decrease humidity to the
level indicated for the cycle. This time also varies according to the humidity level detected by the
conductivity sensor during the drying phase.
If the cycle has a set time, the duration will depend on the time set, and will not take into account the values
detected by the conductivity sensor.
• COOLING
This has a maximum duration of 5 minutes for timed cycles, whereas for automatic ones it may be less,
according to the temperature inside the drum.
• ANTI-CREASE
This has a duration of 30 minutes which can be extended to 90 minutes if the LONG ANTI-CREASE option
is selected.
The programme cannot be changed after the drying programme has started.
If the position of the selector is changed, the Start/Pause LED and the buzzer will indicate that this operation is
not possible, and the Display will show the message Err.
If any of the buttons are pressed, the Start/Pause LED and the buzzer will indicate that this operation is not
possible, and the Display will show the message Err.
The options can only be entered after a drying program has been selected and the selector is positioned at the
start of the cycle, or during a cycle after first pressing the START/PAUSE button.
To reset a drying cycle the selector must be turned to the OFF position.
5.2 Operation in PAUSE mode
If a drying cycle is running, when the START/PAUSE button is pressed the tumble dryer stops the cycle in
progress, the relevant LED flashes and the display indicates the time remaining until the end of the cycle.
If the selector is turned, all the LEDs flash three times and the buzzer sounds to indicate that this operation is
not allowed.
Only certain options can be changed in this mode.
If you press the button for an option that is not allowed in the current programme, the relevant LED and the
Start/Pause LED will flash and the buzzer will sound to indicate that the operation is not allowed. The display
will show the message Err.
When you press the START/PAUSE button again, the drying cycle will recommence from the point at which it
stopped.
To Next Page
Loading...
