Elma Elmasteam 8 basic - Connecting the Device to the Mains Supply

Commissioning
28
BA_Elmasteam_8_Vers.07.2016 © Elma Schmidbauer GmbH
DANGER
Risk of electric shock!
Serious injuries / death!
• Connect the device to a suitable mains supply plug
socket
• The technical data on the nameplate (in particular
mains voltage and current connected load) must
correspond with the available connecting
conditions.
• Place the appliance on a dry, flat and stable
surface.
• Ensure adequate ventilation.
• Keep the installation area and housing dry.
• Steam and/or hot water outlets must never point
towards the device.
4.1.1 Assembling the Mains Supply Cable
INFORMATION
Assembling the Mains Supply Plug
• Observe the technical data on the nameplate
(Figure 4.1.1-C)! Make sure that the electrical plug
socket has the same voltage as that indicated on
the nameplate.
• The plug socket for the mains supply cable must
be easily accessible. In an emergency, pull the
mains plug out of the plug socket!
• Inspect the mains supply cable for damage before
using it. A damaged mains supply cable must not
be used!
1. Connect the mains supply cable (Figure 4.1.1-A) to the
connector (Figure 4.1.1-B).
2. Plug the other end of the mains supply cable into the
prescribed plug socket.
Connecting the
Device to the Mains
Supply
Assembling the
Mains Supply
Cable