Elma Elmasteam 8 basic - Cleaning the Sieve in the Water Connection

Safety / Maintenance / Repair Works
© Elma Schmidbauer GmbH BA_Elmasteam_8_Vers.07.2016
83
8.2.1 Cleaning the Sieve in the Water Connection
The sieve in the water connection may become clogged by
particles or minerals in the water supply and the water supply to
the device will be affected.
Depending on the water quality. At the latest when the pressure
vessel is not correctly filled
•
Pull out the mains plug
•
Close off the water supply to the device
1. Remove the hose on the fixed-water supply (Figure 4.4.3-F)
2. Pull out the sieve with pliers
3. Clean the filter under running water
4. Replace the sieve again
5. Correctly reassemble the water connection and inspect it
secure fit and leak tightness.
Figure 8.3.1: Sieve from different views
Intervals
Preparation
Procedural Method