Elma Elmasteam 8 basic - Device Operation; Switching on the Device

Commissioning
© Elma Schmidbauer GmbH BA_Elmasteam_8_Vers.07.2016
39
4.6 Switching on the Device
INFORMATION
Utilise the last programme selection
The device will start up with the last programme
selection when it is switched on. When the machine
has heated up, then you can implement the last
programme which was utilised or switch to another
programme.
Figure 4.6.1: Device, rear side
The mains supply cable is plugged into the appropriate socket.
The commissioning was executed.
1. Switch on (I) the mains supply switch (A). The mains switch
illuminates as green when the device is switched on. The
device will immediately start to heat up when there is sufficient
filling level in the pressure vessel (Chapter 5).
Prerequisite
Switching on the
Device
A