Elma Elmasteam 8 basic - Page 61

Handling in Operation
© Elma Schmidbauer GmbH BA_Elmasteam_8_Vers.07.2016
61
INFORMATION
Electrostatic discharge during working with the
handpiece possible (chapter 2.3).
Figure 7.1.1: Handpiece
Steam operation with the handpiece for soft, strong, steam outlet
or saturated steam.
1. Take the handpiece (C) from the manual unit holder (D).
2. Align the manual unit into an appropriate bucket or sink to
discharge any possible condensate accumulations. Briefly
press the steam button (A) until steam appears.
3. Press steam button (A) to start the steam function. Both
buttons (A+B) can be pressed for the steam function. The
handle of the manual unit heats up slightly.
4. Moisten the material to be cleaned with steam from the
handpiece (C).
5. Release steam button (A) or (A + B) to finish the steam
function.
6. Hang the handpiece back into the manual unit holder.
7.
For devices with compressed air connection (optional).
8.
Press the compressed air button (B) to start the compressed
air function.
9.
Blow the material to be cleaned with compressed air.
10.
Release the compressed air button (B) to finish the
compressed air function.
11. Hang the handpiece (C) back into the manual unit holder (D).
Procedural Method
Compressed air
(option)
B
A
C
D