25
Using both hands, pull thread towards left and insert
thread into slit.
Pull the thread (dotted line in illustration) around the
thread guides following the broken lines indicated on the
machine q.
Pass the thread through the hole in the bobbin from
inside to the outside. Place the bobbin on the bobbin
winder spindle w.
AUTO
9
0
Push bobbin winder spindle to the right. (The LCD touch
screen will show a bobbin winding message.) Holding
the free end of the thread, press the foot control. Stop
machine after the bobbin has made a few turns. Cut the
thread tail close to the hole in the bobbin. Start machine
again to continue winding bobbin. When the bobbin is
fully wound, stop the machine.
NOTE: You can use either the Start/Stop key or foot
control to wind the bobbin. If you use the Start/Stop key,
the foot control cannot be attached.
Move the spindle to the left to return the bobbin winder to
its original position. Remove the bobbin and cut the
thread with the bobbin winder cutter e.
NOTE: Do not move the bobbin winder spindle while the
machine is running.
If the machine is running for more than two minutes
during bobbin winding, it will automatically stop for safety
purposes.
q
w
q
e
To Next Page
Loading...
