ELTEX MES23xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 145
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.152. Global configuration mode commands
Command
Value/Default value
Action
sflow receiver id
{ipv4_address | ipv6_address |
ipv6z_address | url} [port port]
[max-datagram-size byte]
id: (1..8);
port: (1.. 5535)/6343;
byte:positive integer
value/1400
ipv4_address format:
A.B.C.D
ipv6_address format:
X:X:X:X::X;
ipv6z_address format:
X:X:X:X::X%<ID>;
url: (1..158) characters
Specify sflow statistics server address.
- id - sflow server number;
- ipv4_address, ipv6_address, ipv6z_address – IP-address;
- url - host domain name;
- port - port number;
- byte - maximum quantity of bytes that can be sent in a single data
packet.
no sflow receiver id
Delete sflow statistics server address.
sflow receiver
 |
e-ipv6}
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
loopbackloopback_id |
vlan vlan_id | oob}
vlan_id: (1..4094)
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
loopback id: (1..64);
group: (1..16)
Specify a device interface whose IP address will be used as the
default source address for statistics collection.
no sflow receiver

Delete the explicitly specified interface whose address is used to
send sflow statistics
Ethernet interface configuration mode commands
Command line prompt in the Ethernet interface configuration mode is as follows:
console# configure
console(config)# interface {gigabitethernet gi_port | tengigabitethernet
te_port | fortygigabitethernet fo_port}
console(config-if)#
Table 5.153. Ethernet interface configuration mode commands
Command
Value/Default value
Action
sflow flow-sampling rate id
[max-header-size bytes]
rate: (1024..107374823);
id: (0..8);
bytes:(20..256)/128 bytes
Specify the average packet sampling rate. Total sampling rate
is calculated as 1/rate*current_speed.
- rate - average packet sampling rate;
- id - sflow server number;
- bytes - maximum quantity of bytes that will be copied from a
packet sample.
no sflow flow-sampling
Disable sample counter for the port.
sflow counters-sampling
sec id
sec: (15..86400) seconds;
id: (0..8)
Specify the maximum interval between successful packet
samples.
- sec - maximum sampling interval, seconds.
- id - the number of sflow server (set by the sflow receiver
command in the global configuration mode).
no sflow
counterssampling
Disable sample counter for the port.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console>

ELTEX MES23xx Specifications

General

Brand	ELTEX
Model	MES23xx
Category	Switch
Language	English