ELTEX MES23xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 170
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.194 – EXEC mode commands
Command
Value/Default value
Action
show pppoe
intermediateagent info
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channelgroup]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16)
Display settings PPPoE Intermediate Age. If interface is not
explicitly defined in the command the command will be
applied for all intrerfaces where operation of PPPoE IA and all
the trusted ports is permitted.
show pppoe
intermediateagent statistics
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channelgroup]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16)
Display the statistic of PPPoE Intermediate Agent operation. If
interface is not explicitly defined the command will be applied
for all interfaces with accepted PPPoE IA and all the trusted
ports.
clear pppoe
intermediateagent statistics
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16)
Clear PPPoE Intermediate Agent operation statistic. If
interface is not explicitly defined in the command the
command will be applied for all intrerfaces with accepted
PPPoE IA and all the trusted ports.
show pppoe
intermediateagent sessions
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channelgroup]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16)
Display all the registered client sessions. If interface is not
exactly defined in the command all sessions will be shown
with sorting by interfaces.
clear pppoe
intermediateagent sessions
[mac-address]
mac address: (H.H.H or
H:H:H:H:H:H or H-H-H-
H-H-H)
Close the client session. If MAC address is not specified all
sessions will be closed.
11.2 DHCP Server Configuration
DHCP server performs centralised management of network addresses and corresponding
configuration parameters, and automatically provides them to subscribers. This avoid having to manually
configure network devices and reduces errors.
Ethernet switches can operate in both modes: DHCP client (obtaining an IP address from a DHCP
server) and DHCP server. If the DHCP server is disabled, the switches can operate with the DHCP Relay.
Global configuration mode commands
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.195. Global configuration mode commands
Command
Value/Default value
Action
ip dhcp server
-/disabled
Enable the DHCP server function for the switch.
no ip dhcp server
Disable the DHCP server function for the switch.

ELTEX MES23xx Specifications

General

Brand	ELTEX
Model	MES23xx
Category	Switch
Language	English