ELTEX MES23xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 137
permit ip-source
{ipv4_address |
ipv6_address/prefix_length}
[mask {mask | prefix_length}]
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group | oob |
vlan vlan_id] [service service]
http, https, ssh)
deny
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group | oob |
vlan vlan_id] [service service]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094);
service: (telnet, snmp,
http, https, ssh).
Specify a restricting criterion for an ACL.
- service - access type.
deny ip-source
{ipv4_address |
ipv6_address/prefix_length}
[mask {mask | prefix_length}]
[gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
portchannel group | oob |
vlan vlan_id] [service service]
Privileged EXEC mode commands
Command line prompt in the Privileged EXEC mode is as follows:
console#
Table 5.139. Privileged EXEC mode commands
Command
Value/Default value
Action
show management access-list
[name]
name: (1..32) characters
Show access control lists.
show management access-class
-
Show information on the active access control lists.
7.4.8 Access configuration
7.4.8.1 Telnet, SSH, HTTP and FTP
These commands are used to configure access servers that manage switches. TELNET and SSH
support allows remote connection to the switch for monitoring and configuration purposes.
Global configuration mode commands
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.140. Global configuration mode commands
Command
Value/Default
value
Action
ip telnet server
Telnet server is
enabled by default.
Enable remote device configuration via
Telnet.
no ip telnet server
Disable remote device configuration via
Telnet.

ELTEX MES23xx Specifications

General

Brand	ELTEX
Model	MES23xx
Category	Switch
Language	English