MES53xx, MES33xx, MES23xx Ethernet Switch Series 28
3 INSTALLATION AND CONNECTION
This section describes installation of the equipment into a rack and connection to a power supply.
3.1 Support brackets mounting
The delivery package includes support brackets for rack installation and mounting screws to fix the
device case on the brackets. To install the support brackets:
Figure 20. Support brackets mounting
1. Align four mounting holes in the support bracket with the corresponding holes in the side
panel of the device.
2. Use a screwdriver to screw the support bracket to the case.
3. Repeat steps 1 and 2 for the second support bracket.
3.2 Device rack installation
To install the device to the rack:
1. Attach the device to the vertical guides of the rack.
2. Align mounting holes in the support bracket with the corresponding holes in the rack
guides. Use the holes of the same level on both sides of the guides to ensure horizontal
installation of the device.
3. Use a screwdriver to screw the switch to the rack.
To Next Page
Loading...
Need help?
General
