ELTEX MES23xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 165
Source MAC address: ARP requests and responses are checked
for correspondence between the MAC address in the Ethernet
header and the source MAC address in the ARP content.
Destination MAC address: ARP responses are checked for
correspondence between the MAC address in the Ethernet
header and the target MAC address in the ARP content.
IP address: ARP packet content is checked for incorrect IP
addresses.
no ip arp inspection
validate
Disable specific checks for ARP inspection.
ip arp inspection list create
name
name: (1..32) characters
1. Create a list of static ARP mappings.
2. Enter ARP list configuration mode.
no ip arp inspection list
create name
Remove a list of static ARP mappings.
ip arp inspection list assign
vlan_id
vlan_id: (1..4094)
Assign a list of static ARP mappings to the selected VLAN.
no ip arp inspection list
assign vlan_id
Unassign a list of static ARP mappings to the selected VLAN.
ip arp inspection logging
interval {seconds | infinite}
seconds: (0..86400)/5
seconds
Specify the minimum interval between ARP information
messages sent to the log.
- set '0' to generate messages immediately;
- infinite - do not generate the log messages.
no ip arp inspection
logging interval
Set the default value.
Ethernet or port group interface (interface range) configuration mode commands
Command line prompt in the Ethernet or port group interface configuration mode is as follows:
console(config-if)#
Table 5.186. Ethernet interface and interface group configuration mode commands
Command
Value/Default value
Action
ip arp inspection trust
The interface is not trusted
by default.
Add the interface into the list of trusted interfaces when ARP
inspection is enabled. ARP traffic through a trusted interface is
deemed as safe and is not controlled.
no ip arp inspection trust
Remove the interface from the list of trusted interfaces when
ARP inspection is enabled.
ARP list configuration mode commands
Command line prompt in the ARP list configuration mode appears as follows:
console# configure
console(config)# ip arp inspection list create list
console(config-arp-list)#
Table 5.187. ARP list configuration mode commands
Command
Value/Default value
Action
ip ip_address mac-address
mac_address
-
Add a static mapping between IP and MAC address.
no ip ip_address
mac_address
Remove a static mapping between IP and MAC address.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#

ELTEX MES23xx Specifications

General

Brand	ELTEX
Model	MES23xx
Category	Switch
Language	English