ELTEX MES23xx User Manual

MES53xx, MES33xx, MES23xx Ethernet Switch Series 60
no back-pressure
Disable ‘back pressure' function for the interface.
load-average period
period: (5..300)/15
Specify the period during which the interface utilization
statistics is collected.
no load-average
Set the default value.
Global configuration mode commands
Command line prompt in the global configuration mode is as follows:
console(config)#
Table 5.29. Ethernet and Port-Channel interface general configuration mode commands
Command
Value/Default value
Action
port jumbo-frame
-/denied
Enable processing of jumbo fames by the switch.
Maximum transmission unit (MTU) default value is
1,500 bytes.
Configuration changes will take effect after the
switch is restarted.
Maximum transmission unit (MTU) value for port
jumbo-frame configuration is 10,200 bytes.
no port jumbo-frame
Disable processing of jumbo fames by the switch.
errdisable recovery cause
{all | 



 |
-guard |
udld | storm-control |

-/denied
Enable automatic interface activation after it is disconnected
in the following cases:
- loopback-detection - loopback detection;
- port-security -security breach for port security;
- dot1x-src-address - MAC based user authentication failed;
- acl-deny - non-compliance with access lists (ACL);
- stp-bpdu-guard - BPDU Guard activation (unauthorized BPDU
packet transfer on the interface);
- stp-loopback-guard - loopback detection using the STP.
- udld - UDLD protection activation;
- storm-control - broadcast storm;
- link-flapping - link flapping.
no errdisable recovery
cause {all |
loo



 |
-guard |
udld | storm-control |

Set the default value.
errdisable recovery
interval seconds
seconds: (30..86400)/300
seconds
Specify the time period for automatic interface reactivation.
no errdisable recovery
interval
Set the default value.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.30. EXEC mode commands
Command
Value/Default value
Action
clear counters
-
Reset statistics for all interfaces.

ELTEX MES23xx Specifications

General

Brand	ELTEX
Model	MES23xx
Category	Switch
Language	English