MES53xx, MES33xx, MES23xx Ethernet Switch Series 81
no ipv6 address
[ipv6_address/prefix-length
link-local]
Remove the local IPv6 address.
ipv6 nd dad attempts
attempts_number
Specify the number of demand messages sent via the
interface to the device when IPv6 address duplication
(collision) is detected.
Return the default value.
Disable ICMPv6 Destination Unreachable messages for
packet transmission to a specific interface.
Specify MLD version for the interface.
Privileged EXEC mode commands
Command line prompt in the Privileged EXEC mode is as follows:
console#
Table 5.57. Privileged EXEC mode commands
show ipv6 neighbors
{ipv6_address |
gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
vlan vlan_id}
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094)
Show information from the cache on the neighbour IPv6
devices.
Clear the cache that contains the information on neighbour
IPv6 devices. Information on static entries will remain.
EXEC mode commands
Command line prompt in the EXEC mode is as follows:
console#
Table 5.58. EXEC mode commands
show ipv6 interface [brief |
gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channel group |
loopback | vlan vlan_id]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094)
Show IPv6 protocol settings for a specific interface.
show ipv6 route [summary |
local | connected | static |
ospf | icmp | nd |
ipv6_address/ipv6_prefix |
interface
{gigabitethernet gi_port |
tengigabitethernet te_port |
fortygigabitethernet fo_port |
port-channe lgroup |
loopback | vlan vlan id}]
gi_port: (1..8/0/1..48);
te_port: (1..8/0/1..24);
fo_port: (1..8/0/1..4);
group: (1..16);
vlan_id: (1..4094)