13
Install VNX5300 SPS rails
Rear
Front
Alignment pin
Threaded
screw holes
Detail
The rails must be aligned carefully. Two people are required to install the components.
The Standby power supply (SPS) is a 1U component and uses a 1U adjustable rail kit. Start any
installation at the bottom of the space allowed in your cabinet.
1. Insert the adjustable rail slide and seat the alignment pin into the rear channel of
your cabinet.
2. Place the alignment pin into the hole just above a standard unit (U) marking.
3. Extend the rail and align the front of the rails as shown.
4. Insert two retention screws in the front and two retention screws in the back of each rail
as shown in
the illustration.
To Next Page
Loading...
