53
Serial
console
MGMT
CS
B
MODEM socket
VGA plug
A
IPMI port
Control Station 0 Rear
B
MGMT
B
MGMT
1
2
CS 0 B
CS 0 MGMT
Standby power supply
Disk processor enclosure
Control Station
DVD
DVD
Control Station
Control Station 1 Optional
Front
1. Slide Control Station 0 into the slot above the DPE.
2. Install the screws holding the Control Station in place. Do not fully tighten the component
screws until all of the components are in place.
3. Install the extension cables after the Control Station has been installed into the ganged
rail.
4. Repeat steps 1-3 if CS1 is shipped with the order. Otherwise, leave this 1U space empty.
Install the CS and extension cables
To Next Page
Loading...
