EMC VNX5300 - VNX5300 Rear View; Standby Power Supply Rear View

17
Alignment pins
Rear
Disk processor enclosure
Adjustable
rails
4 screws hold the
component in the cabinet
(2 per side)
Standby power supply
Threaded
screw holes
Front
Will Make the Array Unusable
Caution: Array Software on drives 0-4. Removing or relocating them
Install the VNX5300 DPE
CAUTION
The DPE is heavy and should be installed into a rack by two people. To avoid personal injury
and/or damage to the equipment, do not attempt to lift and install the enclosure into a rack
without a mechanical lift or help from another person.
1. Slide the disk processor enclosure (DPE) into the rails in the cabinet.
2. When the DPE is in place, insert the screws from the front and tighten all of the screws.