EMC VNX5300 - Planning Worksheet; Ipv4 Management Port Information; Ipv6 Management Port Information (Manual Configuration Only); Login Information for the Array Administrator

6
Planning Worksheet
With your network administrator, determine the IP addresses and network parameters you plan to use
with the storage system, and record the information on the following worksheet. You must have this
information to set up and initialize the system.
You manage the storage system through a dedicated LAN port on each storage processor. These ports
must share a subnet with the host you use to initialize the system. After initialization, any host on the
same network and with a supported browser can manage the system through the management ports.
In a server with multiple NICs or iSCSI HBAs that are connected directly to the storage system, or that
are on a dedicated iSCSI network, each initiator port must be on a separate subnet.
Record network information for your system on the worksheet on the next pages. Your network
administrator should provide most of this information. For more information, refer to your confi guration
planning guide.
IPv4 Management Port Information:
IP Address Subnet Mask Gateway
SP A:
SP B:
IPv6 Management Port Information (manual confi guration only):
Global prefi x:
Gateway:
NOTE: Do not use 128.221.1.248 through 128.221.1.255, 192.168.1.1, or 192.168.1.2 for an IPv4
IP address.
Login Information for the array administrator:
Username:
Password:
Storage-system serial number:
Scope:
NOTE: The storage-system serial number is located on the PSN tag hanging from the rear of the
chassis. The number is identifi ed as SN/Product ID.