EMC VNX5300 - Power up Procedure for VNX5300; Connect the Power Cables as Follows

64
Power Up procedure for VNX5300.
Note: Verify that the cabinet circuit breakers are in the ON position. If you are installing the VNX5300
into an existing cabinet that contains other components, do not turn off the cabinet circuit breakers.
Ensure that the switch for the Standby Power Supplies are turned OFF.
Connect the power cables as follows:
1. Connect standby power supply B (SPS B) to power distribution panel (PDU B).
2. Connect SPS B to storage processor (SP) B.
3. Connect SPS A to PDU A.
4. Connect SPS A to SP A.
5. Connect Control Station (CS) 0 to PDU B.
6. Connect CS 1 to PDU A.
7. Connect the blade enclosure side B to PDU B.
8. Connect the blade enclosure side A to PDU A.
9. Lock each power cable in place and turn on the SPS power switches.
Your VNX5300 will power up. It may take from 10 to 15 minutes to power up completely.
3
4
2
1
8
7
6
5
Powering up the VNX5300 System