36
Installing a VNX OE patch or software enabler
1. Start the Unisphere Service Manager.
2. Log in to your storage system.
3. Select Software > System Software, and then click Prepare for Installation (Step1).
4. In the welcome page, select Download software only. The wizard determines the revision of
software installed on the system and notifi es you of any required patches or newer releases.
5. Select and download any software that you want to install, and click Finish.
6. Select Install Software to install any patches or software that you downloaded in the previous step,
and to install any enablers that you ordered with your system.
7. Once you have checked for updates and installed software, proceed to the next step.
Register your storage system
The Storage System Registration Wizard sends site and confi guration information to your service
provider. We strongly recommend that you run the wizard now as follows:
1. Verify that the client is connected to both the storage system and to the internet.
2. If the Unisphere Service Manager (USM) is not open, start it now. After logging in to your system,
select the Registration tab and click Register Storage System to start the Storage System
Registration Wizard.
3. Follow the wizard prompts to complete the registration.
What next?
We recommend that you set up either iSCSI or Fibre Channel environments and confi rm its error-free
operation. Complete information on setting up these environments is available online in the customized
documentation available for this storage system.
Update software and register your system
To Next Page
Loading...
