34
Initialize and enroll the storage system
If your server is behind a fi rewall, open the TCP/IP port 2162 (outgoing) and port 2163 (incoming).
The initialization utility will not function properly if these ports are not opened.
2. Run the Storage System Initialization Utility on the host.
a. If the utility did not launch automatically after installation, select Start >
Programs > EMC > Unisphere Initialization from the toolbar.
b. The utility automatically scans the subnet for storage systems. Uninitialized
systems are identifi ed by hardware serial number. (You recorded your
hardware serial number on the worksheet in the Planning steps and worksheets found on
pages 6-8.)
If the discovery operation did not fi nd the storage system that you are installing, verify that the
storage system’s management ports are properly cabled to the LAN on which the host resides. The
storage system and host must both reside on the same subnet.
c. From the Uninitialized Systems list, select the serial number of the storage
system to initialize and click Next.
d. Use your completed worksheets to provide all the information the utility
requests.
When fi nished, the utility boots the storage system.
3. Go to the EMC Product Support site to gain access to software downloads. Be sure that your
storage system is registered on the site.
To Next Page
Loading...
