ControlWave Instruction Manual (CI-ControlWave)
Revised Nov-2010 Service & Troubleshooting 5-9
Figure 5-6. Pulling the I/O Module Out of the Housing
4. If you plan to replace this module with a new module, but want
to retain all your existing I/O wiring to the terminal blocks, you
need to disconnect the terminal block board from the rest of the
module. To do that, loosen the screws at the top and bottom of
the terminal block board. Then grab the handle and pull the
terminal block board along with the terminal housing assembly
off of the front of the module.
To Next Page
Loading...
