Emerson ControlWave - Page 153

ControlWave Instruction Manual (CI-ControlWave)
IND-5 Index Revised: Nov-2010
P
Packaging
modules..........................................2-3
Port 80 display
POST codes..................................5-22
run time status codes....................5-24
Port Configuration switches
for SCB ........................................2-21
Power Supply Sequencer (PSSM)
Module
description......................................1-7
installation......................................2-7
Removing................................2-7, 5-6
Replacing .......................................5-6
Run/Remote/Local switch..............4-1
TB1 Connectors...........................2-16
TB2 Connectors...........................2-12
Wiring..........................................2-10
Power switch......................................4-1
Protocols
supported in ControlWave...........1-10
PSSM ........................ See Power Supply
Sequencer (PSSM) Module
R
Ranges
Isolated LLAI...............................3-43
Redundancy
Enable/Disable switch..................2-20
wiring...........................................2-15
Redundant Power Supply Sequencer
(RPSSM) Module...........................P-1
Remote termination............................ 3-6
Repair in field .................................... 5-5
Reset switch.....................................5-25
Resistance Temperature Device (RTD)
Input Module................................3-35
Wiring..........................................3-36
RPSSM Module.................................P-1
RS-232 ports ....................................2-22
cables for......................................2-23
configuration switches.................2-21
RS-485 ports ....................................2-27
cables for......................................2-27
configuration switches.................2-21
RTD..........................................................
See Resistance Temperature Device
(RTD) Input Module
Run/Remote/Local switch..................4-1
Running diagnostic software............5-25
S
SDRAM memory
amount............................................1-6
Service................................................5-1
Shielding............................................3-6
Site Considerations ............................2-1
Soft Switches
Lock & unlock .............................2-19
Software
used with the ControlWave............1-8
Specifications
for temperature, humidty, vibration 2-
2
SRAM Battery
Disconnecting ..............................5-12
SRAM control switch ...................... 2-20
SRAM memory
amount............................................1-6
Status codes......................................5-22
Switches
CPU Module ................................2-19
power switch..................................4-1
Reset switch.................................5-25
Run/Remote/Local switch..............4-1
System Firmware Downloader .......... 5-2
T
Tables
1-1. CPU Module Configurations..1-5
2-1. Steady State Current Draw for
Bulk Power Supplies................2-12
2-2. CPU Module Switch SW1....2-19
2-3. CPU Module Switch SW3....2-21
2-4. SCB Port Configuration Switches
..................................................2-21
2-5. RS-232 Connectors on CPU.2-23
2-6. RS-232 Connectors on SCB .2-23
2-7. RS-232 Port Connector Pin
Assignment ..............................2-24
2-8. COM3 (on SCB) RS-232 Port
Connector Pin Assignment ......2-25