©2020 EMS Ltd. All rights reserved. Page 12 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
Device log on methods
Wireless devices can be programmed to the WZM in two ways, for maximum flexibility. They are as follows:
Method 1 ‘at WZM’
This method is accessed at the WZM and involves powering the device
at the WZM, by inserting the device’s batteries. Devices can therefore be
added to the system, prior to installing them into location.
Method 2 ‘at device location’
This method is accessed at the WZM and involves applying the supplied
magnet to the device. Devices can therefore be added to the system,
with device batteries already fitted. E.g. when fitted in its final device
location.
The magnet must be held in place (on the device log on point) for 4
seconds. The device’s LED will flash by way of confirmation.
Refer to the ‘Device log on points’ section for details on each device’s
log on point.
To Next Page
Loading...
Need help?
General