©2020 EMS Ltd. All rights reserved. Page 46 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
This section shows how to test the systems devices along with checking device signal and battery levels to
ensure they are operating within the correct parameters. This section can be used as a guide. Local fire
alarm maintenance procedures should be followed to comply with the relevant standards.
Every device should be function tested, to ensure correct functionality.
Test devices
Smoke detectors should be tested using a smoke detector tester and in accordance with local codes of
practice.
Heat detectors should be tested using a heat detector tester and in accordance with local codes of practice.
Call Points should be tested in accordance with local codes of practice.
Sounder operation should also be tested in accordance with local codes of practice.
Input / Output devices should also be tested in conjunction with associated 3rd party equipment and in
accordance with local codes of practice.
To Next Page
Loading...
Need help?
General