©2020 EMS Ltd. All rights reserved. Page 6 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
General warnings
The system should only be installed and programmed by a fully trained competent person.
The procedures outlined in this programming guide and associated instructions must be carefully followed.
All of the options detailed within this programming manual are available via the SmartCell configuration
tool. See the configuration tool’s inbuilt engineer manual for operational details.
Handling precautions
General: care should be taken when handling this wireless fire system. Avoid dropping any of the parts on
to hard surfaces, as damage may occur to the case and internal circuitry.
ESD precautions: This wireless fire system includes components that are susceptible to damage from
Electrostatic Discharge (ESD). Permanent damage may be caused to these components through routine
handling if precautions are not observed. To reduce the risk of damage from ESD, the following precautions
should be observed.
Minimise the handling of PCBs which contain static sensitive components.
Where handling is unavoidable, always ensure that you have taken adequate earthing precautions. An
earthed wrist strap is recommended.
When storing or transporting a “loose” PCB, always use a container, which has been designed and
manufactured with ESD protective properties.
Avoid placing static sensitive devices on any surfaces, which may increase the risk of a static discharge
Packaging
Products should be kept in their packaging until they are due to be installed, to minimise the risk of damage.
Retain all packaging until the installation activities have been completed. Should any product be found to
be surplus to requirements, or require returning to your supplier, the original packaging should be used.
PIN numbers
It is advised that you change the default PIN immediately on first installation and consider changing
frequently to prevent unauthorised access.
!
To Next Page
Loading...
Need help?
General