©2020 EMS Ltd. All rights reserved. Page 57 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
View System Status Event History
Fire Alarms
Faults
Fire Only
Fault Only
All Events
A20 TAMPER
Dual Detector
First Floor Landing
12:05 10/01/20
The example below shows a historical event, logged for a ‘TAMPER’ fault on a device.
Device address
Event type
Device’s text description
Time & date of the event
Access level 3 menu options
View system status
The view system status menu allows the engineer to view the historical event log, along with viewing the
status of individual devices on the system and current disablements/test states. This menu option is
shown in detail below:
Event history
When entered, options are available to view filtered ‘Fire’, or ‘Information’ events only or alternatively, ‘All
Events’ can be viewed. A total number of events for each option is also indicated. When the event option is
entered, the display will show the latest event first. The events can then be scrolled through by using the .
and buttons. Each log entry records the event type, the device’s zone (at the time of the event), the
device address (text description if allocated) and time and date at which the event occurred. The event log
is a scrolling log, shown in chronological order and will automatically overwrite the oldest events when the
1000 event capacity is reached. The log can however be cleared using an access level 3 code and entering
the relevant menu if required. Note: the default access level 3 code is 333333.
1
3
WZM MENUS
To Next Page
Loading...
Need help?
General