©2020 EMS Ltd. All rights reserved. Page 41 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
SYSTEM SETUP
View System Status
Maintenance/Test
Device Options
WZM Settings
Panel Type
Sounder Options
Device Indicator
Default Tone Select
Sounder Duration
Sounder Activation
Pulsed Output
Default Tone Select
Sounder Duration
Sounder Activation
Pulsed Output
If the pulsed out is to be changed , from access level 3 (refer to
the ‘Access level 3’ section for details), press the button
until the screen displays:
Press the button and the screen will display:
Press the button until the screen will displays:
Press the button and the screen will display:
Press the button until the screen will displays:
Press the button and the screen will display:
Press the and buttons, until the screen displays
the required relay type:
In this example, the fault relay has been chosen.
Press the button and the screen will display:
Pulsed output
As default, the pulsed output, for the fire and the fault relays, is set to latched. Upon an activation, the relay
will remain latched in alarm until the WZM is reset. This however can be changed to pulse into alarm for a
pre-defined period of time, before automatically clearing. Permitted times range from 5-60 seconds.
Panel Type
Sounder Options
Device Indicator
Fire Relay- LATCH
Fault Relay- LATCH
Fire Relay- LATCH
Fault Relay- LATCH
Fault Relay
00 LATCH
Secs To Select
To Next Page
Loading...
Need help?
General