To Next Page

To Previous Page

INTRODUCTION

STATUS

FAULT

START

For additional information refer to TSD042

SLIDE TO

REMOVE

WZM Status LEDs

Function

This button is always active and is used for number entry (number 1) and for

upwards menu navigation.

This button is always active and is used for number entry (number 2) and for

forwards menu navigation.

This button is always active and is used for number entry (number 3) and for

downwards menu navigation.

This button is always active and is used for number entry (number 4) and for

backwards menu navigation.

This button is always active and is used as a menu entry button.

When a valid User PIN has been entered, pressing the Function 1 button will

switch between the first and second language selected for the system.

When a valid User PIN has been entered, pressing the Function 2 button for

2-3 seconds will send a resynchronisation signal to the WZM’s wireless

devices.

Button

FUNCTION 1

FUNCTION 2

Function

Illuminates when any device is in fire alarm condition.

Illuminates when any fault condition is present at the

WZM itself or if an associated device is in fault.

Indicates a good power supply.

LED Indicator

FIRE

FAU LT

POWER

LED Colour

WZM buttons

EMS SmartCell Programming Guide

Other manuals for EMS SmartCell