EMS SmartCell - Page 63

©2020 EMS Ltd. All rights reserved. Page 63 of 80 MK067-0001-99 (Issue 1) 04/11/2020 AJM
WZM MENUS
Attribute type
Address number
Device Display Text
Sounder volume
Default setting
Next available address number on system
The device type followed by the devices unique ident number
(where xx = represents the ident number of the device)
High
Sounder
Attribute type
Address number
Device Display Text
Default setting
Next available address number on system
The device type followed by the devices unique ident number
(where xx = represents the ident number of the device)
Fire manual call point
Remove device
This section allows wireless devices to be removed from the system. A list of devices already allocated to the
system are shown, these can be scrolled through by using the and buttons. The required device to
be removed can be selected by using the button.
Edit settings
This menu allows the user to change device text descriptions, allocate the device to a zone, allocate
detection type, select detector sensitivity settings, change sounder volume and I/O operation for inputs and
outputs. All of the above will have default settings. The available options and the default settings are shown
in the following tables for each device type;
Attribute Type
Address number
Device Display Text
Detection
Smoke Sen
Heat Sen
Default setting
Next available address number on system
The device type followed by the devices unique ident number
(where xx = represents the ident number of the device)
Dual
Normal
58°C static
Dual detector
1
3