Attaching the Ethernet-to-RJ11 Communication Cable Between P100 & Printer
Attach Ethernet Plug End to P100 Ethernet Port
Attach RJ11 Connector End to P100 Printer Port & Pull Cable into Cable Pass Through Slot
NOTE: The printer batteries have to be partially charged to be able to run the unit while charging, if
desired. The charger port is next to the RJ11 port on the printer
To Turn on the Printer:
Press (DO NOT HOLD) the green power button. A green LED will turn on. It should be a solid green
light. If it is flashing, or does not come on, the battery is low. Plug it into its power supply and charge for
2-3 hours before use.
To Feed the Label, or Paper Stock:
With the printer power on, hold down the power button until the label/paper stock feed as far as desired.
To Next Page
Loading...
Need help?
General